HEIDENHAIN MANUALplus 4110 - Manual (Page 215)

HEIDENHAIN MANUALplus 4110 215
4.8 Milling Cy
cles
Slot, radial
Call the milling menu.
Select the "Slot, radial" cycle.
This cycle mills a slot on the lateral surface. The slot width equals the
diameter of the milling cutter.
Cycle parameters
 X, Z starting point
 C spindle angle (C-axis position)—default: Current spindle angle
 C1 angle of slot target point —default: Spindle angle C
 X1 milling top edge (diameter)—default: Starting point X
 Z1 target point of slot
 X2 milling floor
 L slot length
 A angle to Z axis —default: 0
 P infeed depth —default: Total depth in one infeed
 FZ infeed rate —default: Active feed rate
 T tool number
 S spindle speed / cutting speed
 F feed per revolution
Parameter combinations for the position and orientation of the slot:
See graphic support window
Cycle run
1 Activate the C axis and position to spindle angle C at rapid traverse
(only in Teach-in mode).
2 Move at rapid traverse to slot starting point X, Z if defined.
3 Approach at infeed rate FZ.
4 Mill to slot end point at programmed feed rate.
5 Retract to starting point X.