WattMaster WCC II - Manual (Page 72)

Section 3: Screen Descriptions
WCC II Operator’s Guide
Operator Interfaces 3-40
This screen allows you to override addresses within the system for
programmable time periods. The allowable choices for override
type depend on the password level.
With Level 1 Password, choices are
With Level 2 Password, choices are With Level 3 Password, choices are
ADDRESS
This is a user entered fi eld which initiates the Override program of
the ECC II/WCC II system. Addresses which may be used on this
screen are shown below:
#An - Analog Input
#Pn - Analog Output
#KnH - Control Output (H Contact)
#KnC - Control Output (C contact)
Wn - Week Schedule
Sn - Optimal Start
GBn - Binary Global
GAn - Analog Global
Type/Value
The Type or Value of the address is entered in this position. A
binary type of address will have a type of either being ON or OFF.
An analog address will have a numerical value such as °F, PSI,
KW, % Sun, etc.
----- Start -----
----- End -----
The Start and End portion of the program is where you enter the
Time, Month, and Day for the override to occur. If you enter a start
time later than the present time, the override will erase itself from
the screen after the override has been completed.
-----------------------------------------------------------------------------------------
OVERRIDES
-----------Start----------- ------------End------------
ADDRESS Type/Value TIME MONTH DAY TIME MONTH DAY
W12 Off 745 2 15 845 2 15
S5 Off 745 2 15 845 2 15
GB9 On 745 2 15 845 2 15
GA15 72.5 Deg F 950 2 16 1200 2 17
GA10 30.0 Deg F 1130 3 17 2200 3 18
184K2C Schd On 900 4 11 1500 4 14
HOME for menu
-----------------------------------------------------------------------------------------
OVERRIDE SCREEN