WattMaster WCC II - Manual (Page 30)

Section 2: Initiating the System
WCC II Operator’s Guide
Operator Interfaces 2-6
Assign Operator Access Codes
Access codes can be assigned for up to 16 operators with 4 levels
of access. The systems are sent from the factory with an operator
number of 33333 and an access number of 3333. To assign other
codes, follow the steps in this section.
STEP #1 : With the Main Menu showing on the screen, place
the cursor above “System Parameters” and press to
access the System Parameter Screen. The System Parameter
Screen should come into view with the computer awaiting the
operator ID.
STEP #2 : Input the factory set identifi cation number of
33333 and press . The numbers at the top of the
keyboard must be used. The cursor will automatically move to
the right and await the code ID.
STEP #3 : Input the factory set code number of 3333 and
press . The message to the right of the cursor should
change from “ View Screen Only ” to “ View All
Codes .”
STEP #4 : Use the right arrow key to move the cursor to the
right of the “ View All Codes ” message.
STEP #5 : Press , and the screen will appear which
will allow codes for 16 operators with 4 levels of access. The
descriptions of the access levels are listed at the bottom of this
screen.
STEP #6 : Access codes can be assigned for the operators
who will be using the system. The operator ID is 5 characters
using any letters, numbers, or symbols (it is important to
input all 5 characters when inputting an operator code; a
space may be entered as a character if desired). The code ID
is 4 characters using any letters, numbers, or symbols (it is
important to enter all 4 characters for the code ID; a space may
be used as a character if desired). The system will distinguish
between small and capital letters. To assign an operator ID,
type the desired characters and press
. The cursor will
automatically move to the right and await the code ID. Type
the desired code ID and press
. The cursor will now
automatically move to the right and await the Level access
number. Type in this Level number (1 through 3, 1 being the
lowest and 3 being the highest) and press
.
STEP #7 : After the codes have been entered, make sure
you know what the codes are before leaving this screen. We
recommend leaving the 33333, 3333 access code until the
other codes are tested. To leave this screen, press
twice to return to the System Parameter Screen. Press
once more to return to the Main Menu.
Insert Disk #3 in drive A and fi ll out the WCC/SCC
File Management Screen as shown below to copy the
custom screen fi les from drive C to drive A:
---------------------------------------------
File name: *.TXT
New fi lename: A:*.TXT
Direction: WCC
Action: Copy
---------------------------------------------
After the copy process is completed, store the fl oppy
disks in a safe place.
Returning to the ECC/WCC II Program
Dual Disk Drive Systems
If you are using the ECC/WCC II personal computer to copy the
disks, the need to replace the ECC/WCC II disks in the proper
drives and “re-boot” the system by fi rst pressing
and ,
and then pressing . After a couple of minutes, the Main Menu
should appear on the screen.
Hard Disk Drive Systems
Open the door on drive A and “re-boot” the system by pressing
and and then pressing . After a couple of
minutes, the Main Menu should appear on the screen.
CAUTION: The CPU will not communicate with the satellite
controllers while it is going through the “re-boot” process. If
the satellite controllers do not communicate with the CPU for
approximately two minutes, they will go into local set. The
time it takes for the system to “re-boot” will usually cause the
satellite controllers to go into local set.
8.
9.