WattMaster WCC II - Manual (Page 12)

Section 1: General Instructions
WCC II Operator’s Guide
Operator Interfaces 1-2
Service Item As
Req’d
Every
Wk
Every
Mo
Every
3 Mo
Every
6 Mo
Every
12 Mo
Delete“back-
up” (*.bak)
fi les X X
Make “back-
up” copies of
disks X X
Check disks
for available
space to
prevent
overfi lling the
disk X X
Check loop
connection on
rear of CPU X
Save satellite
data to disk X X
Rebuild all
satellite and
global tables X
Test satellites’
local-set
capability X
Test satellites’
battery (or
capacitor) X
Check/Clear
satellite
communica-
tion errors
on
Satellite
Summary
Screen
X X
Run loop test X
Check/Reset
trend logs X X
View/Clear all
alarms X X
Cycle power
to CPU to
verify correct
system re-start
after a power
outage X
* Set the screen’s intensity to the lowest setting when the system
is not being used.
ECC/WCC II Software Version List
The ECC/WCC II software is updated periodically to include more
features. The two fi les that change as the ECC/WCC II system is
upgraded are the WCC2 fi le and the BACKTASK fi le. When a
WCC II fi le is installed in a system, the BACKTASK fi le may need
to be changed also. The following list shows the WCC2 version
numbers and the BACKTASK fi le that must be used with it.
Note: You can see the present WCC2 and BACKTASK
version used by the system by looking at the lower left hand
corner of the Main Menu Screen.
WCC2 Version Minimum BACKTASK Version
1.47* 1.1B
1.48* 1.1B
1.49* 1.1B
1.52 1.22
1.54 1.24
1.6A 1.24
1.6B 1.24
1.63 1.24
1.64 X.2B**
1.65 X.2BB**
1.67 1.2E
1.68 1.2E
1.69 1.4A
1.70 1.4A
1.71 1.4B
1.72 1.4B
1.74 1.4D
* These versions of software require the front end computer to
have 448K of RAM memory; later versions require 640K.
**X = 1 to 3
1 = IBM PC or XT
2 = IBM XT 286
3 = 3 satellite system