WattMaster WCC II - Manual (Page 45)

Section 3: Screen Descriptions
WCC II Operator’s Guide
Operator Interfaces 3-13
Control Out
Specifi es the summary type to be displayed. Because this is a
“choice” fi eld, the list of available choices will be displayed at the
bottom of the screen:
CHOICES:
You may make your selection by pressing the until
the desired summary type appears and then pressing .
If you select a summary type that is different than that currently
being displayed, the screen will be rewritten with the new screen
information.
Satellite ______
Specifi es the number of the satellite which you are currently
communicating with. If you would like to view the control output
summary data for a different satellite, use the arrow keys to move
the cursor to this fi eld, enter the desired satellite number, and press
.
To view or edit a specifi c control output, use the arrow keys to
position the cursor (shown as “>” along the left hand side of the
screen) to the desired point and press
. The Control Output
Screen for the specifi c point will now appear.
Time Date
The present time and date will automatically appear at these
locations.
COMMENTS
The description message which was entered on the control output
screen is displayed here to help you identify the different control
outputs within the system.
-----------------------------------------------------------------------------------------
Control Out Satellite 1 Time Date
----------Control Outputs---------- 17:07 7/07
SCHED ANALOG CONTROL LIMIT
COMMENTS STATUS STATUS MODE CONTROL INPUT LOW HIGH
Klh: RM101 GHLT Lght On + W1
c: AHU #1 Fan On + GB2 76.2 Deg F 74.0 200.0
K2 VAV BOX Idle + GB2 74.7 Deg F set = 74.0
K3h:
c:
K4h:
c:
K5h:
c:
K6h:
c:
K7h:
c:
K8h:
c:
HOME for menu
-----------------------------------------------------------------------------------------
CONTROL OUTPUT SUMMARY SCREEN