WattMaster WCC II - Manual (Page 192)

Section 4: Remote Communications
WCC II Operator’s Guide
Operator Interfaces 4-4
OPERATION INSTRUCTIONS
To use the remote computer, install the “software key” and then
insert the newly made FCC/SCC II disk into drive A (left drive)
of the computer. If the computer is off, turn the computer on, and
close the disk drive door. If the computer is on, “boot-up” the
system by pressing
, and , holding all three
keys down for an instant and then releasing the keys. You should
see the following messages on the screen.
A> racctask
Racctask V#.## successfully loaded
A> go2
Racctask V#.## successfully enabled
A> scc2
After the boot-up process is completed, the Main Menu for the
FCC/SCC II system should appear on the screen.
Note: Once “racctask” has been loaded, it will be running in
the background as long as the computer remains powered-up.
If you try to re-boot the FCC/SCC II software with “racctask”
already present in the background, the FCC/SCC II software
will not work. If “racctask” is present in the background and
you need to reload the FCC/WCC II software, you must turn
the computer off to remove “racctask” from the background
before reloading the FCC/SCC II software.
If the remote FCC/SCC II Main Menu Screen does not appear on
the screen, and the A> reappears, chances are the system did not
see the key. The key must be in parallel port #1 (LPT1), and the
board which accepts the key must be 100% IBM compatible.
Notes: