WattMaster WCC II - Manual (Page 138)

Section 3: Screen Descriptions
WCC II Operator’s Guide
Operator Interfaces 3-106
Logical Address Search
This feature allows you to trace a “logical address” and fi nd where
it is used within the ECC/WCC II system. A “logical address” is
an analog input, binary input, analog output, binary output, week
schedule, optimal start, global analog, or global binary.
For example, if you want to change week schedule #1 (W1) you
can use this feature to fi nd all of the screens that use W1, so you
don’t accidentally change the schedule for more zones than you
intended to.
Update Table
When you access this screen for the fi rst time, it will automatically
go through a process of searching for each satellite controller on
the loop and storing the required information in a data table. If
you make any changes to the system after the tables have been
built, you need to manually force the system to search the satellites
again by moving the cursor to the “Home” position on the Logical
Address Search Screen and pressing
and then , holding
both keys down for an instant and then releasing both keys at the
same time.
A message will appear at the bottom of the screen asking which
satellite is to be rebuilt. Input the number of the satellite and press
.
Note: Rebuilding tables for Search Screens is an entirely
different function from rebuilding data tables from the Utility
Screen.
Rebuild Global Table: Yes
The global tables must be rebuilt after changes to one or more of
the following screens:
Optimal Start Screens Duty Cycle Screens
Global Analog Screens Proportional Reset Screens
Global Binary Screens Shed/Restore Screens
Logical Address to Match: W1
The “name” of the “logical address” you want to trace is input in
this fi eld. For example, if you want to trace analog input #3 on
satellite controller #2, you input 2A3. This fi eld is upper and lower
case sensitive, so you must use capital letters when you input the
names.
Logical
Address
Input Form
(Name)
Comment
Analog Inputs 2A3 Analog input #3 on Satellite #2
Binary Inputs 4L2 Binary input #2 on Satellite #4
Analog Outputs 7P6 Analog Output #6 on Satellite #7
Binary Outputs 3K1c COM to C contact on channel #1
of Satellite controller #3
Optimal Start S12 Optimal Start #12
Global Analog GA3 Global Analog #3
Global Binary GB27 Global Binary #27
LOGICAL ADDRESS SEARCH SCREEN
-----------------------------------------------------------------------------------------
-
Logical Address Search
Logical Address to Match: W1 Continue Present Search: NO
Rebuild global table: No
Logical Address Location
1: W1 1A1
2: W1 1A4
3: W1 1A7
4: W1 1k3h
5: W1 GB1
6: W1 GB12
7: W1 S1
-----------------------------------------------------------------------------------------