WattMaster WCC II - Manual (Page 209)

Section 5: Installation Guide
WCC II Operator’s Guide
Operator Interfaces 5-7
SATELLITE CONTROLLER
Mounting in an Enclosure
The satellite controllers are designed to mount in any standard,
six inch deep, ventilated electrical enclosure. Typically, this fi eld-
mounted enclosure contains transformers and any accessory items
required such as a binary input board, control relay, etc. The best
location for these panels is wall mounted in equipment or storage
rooms at eye level near the controlled loads.
The satellite controllers may be ordered with or without the
enclosure. If you order the satellite controller from the factory
without an enclosure, the following SAT II dimensions may be
helpful when selecting an enclosure: