WattMaster WCC II - Manual (Page 204)

Section 5: Installation Guide
WCC II Operator’s Guide
Operator Interfaces 5-2
MODEM SWITCH SETTINGS
The modems must be confi gured to be compatible with the ECC/
WCC II system. The modem may be either a Hayes Smartmodem
1200, an ADC Phone Modem 1200, a Capetronics 1200, or an
Okidata Okitel 1200.
Hayes Smartmodem 1200
If you are using a Hayes Smartmodem, the confi guration switches
are located behind the front cover of the modem which is removed
with a small tool as shown below:
After you remove the cover, you will see a row of small toggle
switches. Newer Hayes modems have 10 switches, and older
Hayes modems have 8 switches. A “10-switch” modem must be
used with the ECC/WCC II system (computer on-site). The remote
computer can use either the 8 switch or the 10 switch modem. The
switch settings need to be in the following positions:
ECC/WCC II FCC/SCC II Remote Printer
(On-Site Computer) (Remote Computer) (300 or 1200 Baud)
1. Up 1. Up 1. Up
2. Down 2. Down 2. Down
3. Up 3. Up 3. Up
4. Down 4. Down 4. Down
5. Down 5. Down 5. Up
6. Up 6. Up 6. Down
7. Up 7. Up 7. Up
8. Down 8. Down 8. Up
9. Up 9. Up (If present) 9. Up (If present)
10. Up 10. Up (If present) 10. Up (If present)