WattMaster WCC II - Manual (Page 181)

Section 3: Screen Descriptions
WCC II Operator’s Guide
Operator Interfaces 3-149
EA DRIVER SCREEN
The ECC/WCC II looks at the SAT II-B as 4 satellite controllers
and forces the Control Output Screens to be in the EA driver mode
to allow the user to input the following control information from
the Operator Control Console:
Schedule control.
Space temperature setpoint.
Morning warm-up period.
The EA Driver Screen is accessed from the ECC/WCC II System
Main Menu. With the Main Menu showing on the screen, place the
cursor above “Control Outputs” and press
. The Control
Output Summary Screen shown on the next page should come into
view.
The EA Driver Summary Screen is slightly different when TUC-
VR’s are used. The status feature is not supported with TUC-VR’s.
An idle, -->C, or -->H message will appear here at random.
To access the EA Driver Setup Screen, use the arrow keys to move
the cursor down to the desired “KnH:” and press
. The
Control Output Screen should appear. If you are accessing this
screen for the fi rst time, the screen will be a “Timeclock” mode.
Use the arrow keys to move the cursor to “Mode:” and press the
until “EA Driver” appears; then press .
1.
2.
3.