WattMaster WCC II - Manual (Page 145)

Section 3: Screen Descriptions
WCC II Operator’s Guide
Operator Interfaces 3-113
Delete a Point Address on the Custom Screen
To delete a point on the Custom Screen, fi rst you must have the
cursor in the exact location it was when the point was placed
on the screen. To simplify fi nding this location, you may move
the cursor near the existing point and then press
and
simultaneously to cause the cursor to move to the exact position
where the point was created. You may delete the point by pressing
and simultaneously, and then pressing . The
four slashes (////) will then appear. You may enter a new point, or to
remove the slashes, leave the screen by pressing
twice,
and then re-access the screen.
Notes: