WattMaster WCC II - Manual (Page 179)

Section 3: Screen Descriptions
WCC II Operator’s Guide
Operator Interfaces 3-147
The TUC-VR is designed to use either the 4-wire WRS-1FVR fl ush
mount temperature sensor or the 4-wire TRS-VR room thermostat.
The space temperature sensor or thermostat is wired directly to the
TUC-VR.
The Analog Input Screens are used to scale the values of the
temperature sensors. The TUC-VR is limited to reading a
temperature from 40 °F to 95 °F. However, the scaling values on
the Analog Input Screen must be set up as shown below:
Units @ 0% scale: 0 Deg F
@ full scale: 100 Deg F
The other inputs on the Analog Input Screen are set up the same as
for a SAT II controller with the exception of the data pattern value
always being forced to x,xxx.
TUC-VR ANALOG INPUT SCREEN
-----------------------------------------------------------------------------------------
Satellite # 1 ANALOG INPUT # 1
Description: RM101 Type: Analog
Pattern for values associated with this input: x,xxx
Units @ 0% scale: 0 Deg F Units of Measure message #: 1
@ full scale: 100 Deg F Filter Time Constant: 8 seconds
--------------------------ALARMS---------------------------
Controlled by: W1 Limits Low High
Alarm Type: 1 On 65 80 Deg F
Alarm Message #’s: Low 2 High 1 Off 50 100 Deg F
Alternate limits selected by: .... On (alt) 0 0 Deg F
Off (alt) 0 0 Deg F
Limit overlap time
after control change: 20 Minutes Local set 55 90 Deg F
-----------------------------BINARY SETPOINT------------------------
OFF Above 0 Deg F On Message #: 0
OFF Below 0 Deg F Off Message #: 0
HOME for menu
----------------------------------------------------------------------------------------------------------------------------------------------------------------------