WattMaster WCC II - Manual (Page 112)

Section 3: Screen Descriptions
WCC II Operator’s Guide
Operator Interfaces 3-80
BINARY GLOBALS
The ECC/WCC II system has 256 binary globals. The term
“binary” simply means a value which is represented by one of
two conditions, ON or OFF. The term “global” means information
which is shared by all of the satellite controllers in the system.
Therefore, a “binary global” is an ON/OFF value which can be
used by any satellite controller within the ECC/WCC II system.
BINARY:
Specifi es the summary type to be displayed. Because this is a
choice fi eld, the list of available choices will be displayed at the
bottom of the screen:
CHOICES:
Make your selection by pressing the once for each
choice until the desired summary type has been selected, and then
press
. (If you select a summary type that is different than
that currently being displayed, the screen will be rewritten with the
appropriate screen information.
To view or edit a specifi c binary global, simply position the cursor
(shown as “>” along the left hand side of the screen) using the
cursor positioning (arrow) to the desired point and press
.
The Binary Global Screen for the specifi ed point will now appear.
Description
The description message which was entered on the Binary Global
Screen is displayed here to aid you in identifying the different
binary globals within the system.
Binary Global Summary Screen
-----------------------------------------------------------------------------------------
BINARY Global Summary GB 1 Time Date
10:02 7/07
Description State Alarm Time
GB1: GLOBAL BINARY #1 OFF Off
GB2:
GB3:
GB4:
GB5:
GB6:
GB7:
GB8:
GB9:
GB10:
GB11:
GB12:
GB13:
GB14:
GB15:
GB16:
GB17:
GB18:
GB19:
GB20:
HOME for menu
-----------------------------------------------------------------------------------------