WattMaster WCC II - Manual (Page 139)

Section 3: Screen Descriptions
WCC II Operator’s Guide
Operator Interfaces 3-107
Location:
The screen(s) which contain the “logical address” as one of their
inputs is displayed under the “Location” heading. The following
designations are used for the various screens.
Logical Address Input
Form
(Name)
Comment
Analog Inputs 2A3 Analog input #3 on Satellite #2
Binary Inputs 4L2 Binary input #2 on Satellite #4
Analog Outputs 7P6 Analog Output #6 on Satellite #7
Binary Outputs 3K1c COM to C contact on channel #1 of
Satellite controller #3
Trend Logs
Analog Trend 4T3a Analog Trend #3 on Satellite #4
Change of State 6T2c Change of State #2 on Satellite #6
Run Time 3T8r Run Time #8 on Satellite #3
Analog Peak 7T5p Analog Peak #5 on Satellite #7
Optimal Start S12 Optimal Start #12
Global Analog GA3 Global Analog #3
Global Binary GB27 Global Binary #27
Shed/Restore SR5 Shed Restore Screen #5
Duty Cycle DU2 Duty Cycle Screen #2
Proportional PROP1 Proportional Reset Screen #1
The fi rst twenty addresses will appear on the screen. If more than
twenty addresses match the description, use the arrow keys to move
the cursor down to the area on the screen where the addresses are
displayed and press
.
Continue Present Search: NO
You can eliminate the unwanted zones on the screen by moving the
cursor to “Continue Present Search,” pressing the
until “Yes” appears, and then pressing . Now move the
cursor to “String to Match” and enter the rest of the description that
you want to match.
Screen Access
You can access the screen which uses the “logical address” by
using the arrow keys to position the cursor (>) at the left of the
desired point and pressing
.