Measurement Computing DBK Part 2 - Manual (Page 75)

DaqBook/100 Series & /200 Series and DaqBoard [ISA type] Configuration
Use of the DBK45 requires setting jumpers in DaqBooks/100 Series & /200 Series devices and
ISA-type DaqBoards.
1.
If not using auxiliary power, set the JP1 jumper for Analog Option Card Use (also referred to
as Analog Expansion Mode).
Note:
These jumpers do not
apply to /2000 Series
devices.
Jumpers on DaqBook/100 Series, DaqBook/200 Series, and ISA-type DaqBoards
The JP1 default position (Analog Option Card Use) is necessary to power the interface
circuitry of the DBK45 via the internal ±15 VDC power supply. If using auxiliary
power, e.g., DBK32A or DBK33, you must remove both JP1 jumpers. Refer to
Power Requirements in the DBK Basics section and the DBK32A and DBK33 sections for
more information, as applicable.
2.
Place the JP2 jumper in the SSH position.
CAUTION
Do not use an external voltage reference for DAC1. Applying an external voltage
reference for DAC1, when using the SSH output, will result in equipment damage
due to a conflict on P1, pin #26.
3.
For DaqBook/100, DaqBook/112 and DaqBook/120 only, place the JP4 jumper in
single-ended mode.
DaqBook/2000 Series and DaqBoard/2000 Series Configuration
No hardware configuration is required for DaqBook/2000 Series or DaqBoard/2000 Series devices.
Software Setup
Reference Notes:
o
DaqView users - Refer to chapter 3, DBK Setup in DaqView.
o
LogView users - Refer to chapter 4, DBK Setup in LogView.
DBK Option Cards and Modules 987696 DBK45, pg. 5