Measurement Computing DBK Part 2 - Manual (Page 136)

Configuring the Primary Data Acquisition Device
DaqBook/100 Series & /200 Series and DaqBoard [ISA type] Configuration
Use of a DBK65 with a DaqBook/100 Series, DaqBook/200 Series, or with an ISA-type DaqBoard device
requires the configuration of jumpers JP1 and JP4 located on that device, as applicable.
1.
If not using auxiliary power, set the JP1 jumper for Analog Option Card Use [also referred to as the
expanded analog mode].
Note:
These jumpers do
not apply to /2000
Series Devices.
Required Jumper Settings for DaqBook/100 Series,
DaqBook /200 Series, and ISA-Type DaqBoards
The JP1 default position (above) is necessary to power the interface circuitry of the
DBK65 via the internal ±15 VDC power supply.
If using auxiliary power you must
remove both JP1 jumpers.
2.
For DaqBook/100, DaqBook /112, and DaqBook /120 only, place the JP4 jumper in the single-ended
mode.
Note: Analog expansion cards convert all input signals to single-ended voltages that are referenced to
analog common.
DaqBook/2000 Series & DaqBoard/2000 Series
No jumper configurations are required on the DaqBook/2000 series and DaqBoard/2000 series devices in
regard to connecting a DBK65.
LogBooks
No jumper configurations are required on LogBook devices in regard to connecting a DBK65.
DBK65 pg. 8 988793 DBK Option Cards and Modules