beautypg.com

Dbk80, 16-ch differential voltage input card, Dbk80, Channel differential voltage input card – Measurement Computing DBK Part 2 User Manual

Page 145: Overview

background image

DBK80

16-Channel Differential Voltage Input Card

with Excitation Output

Overview …… 1
Hardware Setup …… 2

Card Connection …… 2

Card Configuration …… 4

DaqBook/100 Series & /200 Series and DaqBoard [ISA type] Configuration …… 5

DaqBook/2000 Series and DaqBoard/2000 Series Configuration …… 6

Software Setup …… 6
DBK80 – Specifications …… 6

Reference Notes:

o

Chapter 2 includes pinouts for P1, P2, P3, and P4. Refer to pinouts applicable to your

system, as needed.

o

In regard to calculating system power requirements, refer to DBK Basics located near

the front of this manual.

Overview

The DBK80 is a low-noise, high-speed, unity-gain multiplexer card that provides 16 channels of
differential voltage input. Up to 16 such cards can be attached to a single Daq device, providing a possible
256 differential input channels. The card’s unity gain combines with DaqBook, DaqBoard, and LogBook
gains to accept full scale inputs from

±156 mV to ±10 V. The DBK80’s expansion channels can be

scanned at the maximum 200 kHz rate while maintaining measurement integrity.

The DBK80 includes an on-board excitation voltage source that is jumper-selectable to be +5 or +10 VDC.
This source can be used to bias transducers or to measure resistors and thermistors without additional
instrumentation.

Note 1: Offset adjustment is only intended for use during

calibration.

Note 2: JP2 is used to select an excitation source output

voltage of +5 VDC or +10 VDC. The factory default

is +5 VDC.

DBK80 Block Diagram

DBK Option Cards and Modules

989494

DBK80 pg. 1

This manual is related to the following products: