Dbk601 through dbk609, termination panels, Dbk601, Dbk609 – Measurement Computing DBK Part 2 User Manual
Page 305: Through, Termination panels, Warning, Dbk600 series termination panels, Dbk option cards and modules
DBK601
through
DBK609
Termination Panels
For use with DaqBook/260, DBK60, and LogBook/360
Reference Notes:
DaqBook/260 users – refer to the DaqBook/100 Series & /200 Series User’s Manual
(p/n 457-0906) for installation instructions.
DBK60 users – refer to the DBK60 document module that is included in the DBK Option Cards &
Modules User’s Manual (p/n 457-0905).
LogBook/360 users – refer to the LogBook User’s Manual (p/n 461-0901) for installation
instructions.
The rear panels of the DaqBook/260, DBK60, and the LogBook/360 are each customized through the use of
three termination panels. The three panels can be a combination of the following 600-series DBKs.
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
K
CHROM +
ALUMEL -
15
16
17
23
18
24
19
25
20
26
21
27
22
28
A
B
B
C
C
A
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1
+
+
+
+
+
+
-
-
-
-
-
+
-
-
+
-
2
3
4
5
6
7
8
A
B
B
C
C
A
DBK605-R
DBK605-S
DBK605-T
DBK600 Series Termination Panels
WARNING
Electrical Shock Hazard! To avoid possible injury and equipment damage, turn off power
to devices and connected equipment prior to setup.
The signal inputs, from DBK cards, connect directly to the 600-series termination panels, with exception of the
DBK601 (blank panel) and the DBK607 (strain relief clamp). In the case of the DBK601 (blank panel), there
are no connections. In regard to DBK607, wires pass through a slot in the panel, and are clamped.
The remaining 600-series DBKs have different ways in which DBK cards connect to the termination panels
(see following figure). Some points to note:
•
Single-ended connections use analog common.
•
Differential connections require the proper polarity, typically red-to-red for high (+) and
black-to-black for low (-).
•
For thermocouples, red is generally the low side.
•
The T/C connector and wire type must match the T/C type used.
DBK Option Cards and Modules
987594
DBK601 thru DBK609 1