Measurement Computing DBK Part 2 - Manual (Page 173)

Analog Common
DBK85’s analog common connector is located just left of the channel 1 BNC. The connector is typically
used to provide a ground reference point for differential measurements as discussed in the Signal
Management section of Chapter 1.
Software Setup
The DBK85 has no special software settings. The software controls are equivalent to those for a direct
connection; e.g., for a DaqBoard/2000 Series board there are Type selections of x1 to x64, representing the
internal gain of that board. When using the DBK85 with that board you will have the same Type options
since the DBK85 has a fixed gain of x1.
LogView does not include the means to directly select a DBK85. To use a DBK85 with
LogBook, select DBK80. This will recognize the DBK85, but will identify it as a
DBK80.
Reference Notes:
o
DaqView users - Refer to Chapter 3, DBK Setup in DaqView.
o
LogView users - Refer to Chapter 4, DBK Setup in LogView. See above note.
DBK Option Cards and Modules 988793 DBK85 pg. 5