beautypg.com

Software setup, Dbk80 - specifications – Measurement Computing DBK Part 2 User Manual

Page 150

background image

DaqBook/2000 Series and DaqBoard/2000 Series Configuration

No jumper configurations are required for the /2000 series devices.

Software Setup

The DBK80 has no special software settings. The software controls are equivalent to those for a direct
connection; e.g., for a DaqBoard/2000 Series board there are Type selections of x1 to x64, representing the
internal gain of that board. When using the DBK80 with that board you will have the same Type options,
since the DBK80 is always a constant gain of x1.

Note that there is no software control related to the excitation source. The selection of a +5 VDC or
+10 VDC source is determined by JP2.

Reference Notes:

o

DaqView users - Refer to Chapter 3, DBK Setup in DaqView.

o

LogView users - Refer to Chapter 4, DBK Setup in LogView.


DBK80 - Specifications

Connector: DBK37 male, mates with P1 pinout on a DaqBook, DaqBoard,

or LogBook. The board includes screw-terminals for signal connection.

Gain Ranges: 1, x1
Inputs: 16 differential voltage inputs
Maximum Voltage Range: ±10 V
Input Impedance: 20M Ohm
Accuracy: ±[0.025% +150 µV] (typ), ±[0.1% +250 µV] (max)
Noise: 60 µVrms (typ)
Maximum Input Voltage (without damage): ±25 V
3 dB Bandwidth: 2.6 MHz
CMRR: 80 dB typ
Excitation Voltage: 1 channel, jumper-selectable to +5 V or +10 V
Excitation Voltage Accuracy: ±0.5%
Excitation Voltage Current Limit: 20 mA Src, 1 mA Sink
Power: 25 mA max from ±15 V (with no load on excitation voltage)

DBK80 pg. 6

989494

DBK Option Cards and Modules

This manual is related to the following products: