KEYENCE LT-9001 Series - Manual (Page 71)

4
Chapter
Operations
and
Fun
ction
Settings
in
the
Profile
Mode
E LT-9001-IM
Measurement Screen
4-5
The measured value and the profile of the
measuring target can be displayed in the
measurement screen.
You can specify two types of settings, OUT1 and
OUT2, modifying the measured value for the
respective purposes such as averaging, offset
and calibration. These values can be displayed.
Refer to "OUT settings" (page 4-12) for details.
Single display of OUT1 or OUT2
Displays OUT1 or OUT2 individually.
Also displays the measured value and the judgment
determined by the tolerance.
Double display of OUT1 and OUT2
Displays OUT1 and OUT2 at the same time.
You can see two types of measured values on the
screen.
Display of Measured Value
Switching the single and double display
The single display and double display of OUT1/OUT2
can be switched by pressing the [ ▲] and [▼]
buttons.
Measured value Measured value display
The areas within the range Judgment displays [GO] in
between the upper and green.
lower limits [ LIMITS]
(Tolerance)
Over the upper limit Judgment displays [HI] in red.
[LIMITS] (Tolerance)
Under the lower limit Judgment displays [LO] in red.
[LIMITS] (Tolerance)
Measured value Measured value display
The areas within the range Displayed in green.
between the upper and
lower limits [LIMITS]
(Tolerance)
Over the upper and Displayed in red.
lower limits [LIMITS]
(Tolerance)
OUT1
Single
display
OUT2
Single
display
OUT1/
OUT2
Double
display