KEYENCE LT-9001 Series - Manual (Page 148)

8-18
Outputting Measured Values by Using External Synchronization
• The measured value at the instant the TIMING input turns ON is output if the measurement mode is set to
normal, auto peak hold, auto bottom hold, or auto peak-to-peak hold.
• The measured value fixed when the TIMING input turns ON is output if the measurement mode is set to peak
hold, bottom hold, peak-to-peak hold, average hold or sample hold.
The command format when [D-MODE] is set to [S1] or [S2] is shown below.
The command format when [D-MODE] is set to [S0] is shown below.
Output format
Timing Chart
E LT-9001-IM
RS-232C
8
Chapter