KEYENCE LT-9001 Series - Manual (Page 65)

3
Chapter
Operations
and
Fun
ction
Settings
in
the
Displacement
Mo
de
E LT-9001-IM
3-19
OPTIONAL Settings
This section describes the auto slant correction
function used to correct measurement errors
caused by tilted or angled targets.
Measurement errors will result when measuring
the thickness of a tilted or angled target. The auto
slant correction detects slanting of the target and
corrects the value.
(Supported only in the LT-9010(M))
Auto slant correction
The auto slant correction prevents measurement
errors caused by slanting when measuring the
thickness of a transparent object.
The procedure used to set the auto slant correction is
explained as follows.
1
Select [ CORRECT] from [OPTIONAL] on the
program mode screen.
The correction setting screen appears.
2 Select [AUTO SLANT COR].
3 Select [ON] by using the [ ▲] and [▼] buttons.
CORRECT (Auto slant correction)
4 Press the [ENTER] button.
Auto slant correction is set to ON.
The setting is active only when [MEASUREMENT] is
set to [THICK] and [WIDTH/INTERVAL] is set to
anything other than [OFF] and [4/1].
The slant correction is calculated based on the
surface that is set in OUT1 as measurement target
surface 1.
Reference
Note
SLANT
ADJUST
OFF
SLANT
ADJUST
ON