KEYENCE LT-9001 Series - Manual (Page 35)

2
Chapter
Basic
Operations
E LT-9001-IM
1
Slide the [PROG/RUN] switch downward on
the remote control console to display the
program mode screen.
2 Select [BASIC] by using the [ ▲] and [▼]
buttons and press the [Enter] button.
3
Place the cursor on [SCAN] by using the [
▲]
and [ ▼ ] buttons and press the [ENTER]
button.
4 Place the cursor on [WIDTH/INTERVAL] by
using the [
▲] and [▼] buttons and press the
[ENTER] button.
5 Select [1100/10] by using the [ ▲] and [▼]
buttons and press the [ENTER] button.
6 Slide the [PROG/RUN] switch downward on
the remote control console to display the run
mode screen.
The profile waveform appears.
Setting the scan width/interval is completed.
Setting the upper and lower limits display is
described next.
Setting the Scanning Width/interval
2-17
1
Adjust the height and position of the
measuring unit and fix the distance and
position relating to the measurement target.
How to adjust the distance between a
measurement target and the measuring unit.
It will be easier to adjust by combining the three
methods shown below.
1 Adjust the distance to obtain the smallest possible
red laser spot.
2 Adjust the distance to get the measurement target
into focus.
3 Adjust the distance while reading the profile
waveform graph on the measurement screen.
Setting the scanning width/interval is described
next.
Reference
Adjusting the Distance Between the
Measuring Unit and the Measurement Target