KEYENCE LT-9001 Series - Manual (Page 6)

4
Precaution on CE Marking
It is confirmed that the LT-9001 Series satisfies the requirement of the EU
Directives when the following conditions are fulfilled. Therefore, users must fulfill
the following conditions when the LT-9001 Series is going to be used in EU
Member States.
Precautions on EMC Directive
• Applicable standard (EMI) EN61326-1, Class A
• Applicable standard (EMS) EN61326-1
• Wind the following ferrite core twice on the cable at the position within 50 mm
from the analog output that is on the rear panel of the controller.
Model: ZCAT3035-1330 (Product of TDK)
• Wind the following ferrite core twice on the cable at the position within 200 mm
from the VIDEO output that is on the rear panel of the controller.
Model: ZCAT2035-0930 (Product of TDK)
Precautions on Low Voltage Directive
• Applicable standard EN61010-1
EN60825-1 Laser Class 1
• Overvoltage category II
• Pollution degree 2
• The LT-9001 Series is classified as a class 1 laser product.
• When the LT-9001 Series is used in EU Member States, the power supply cable
conforming to the relevant EU standards and obtaining the certification by a
third-party certification organization, and its plug shape fitting to outlets of
respective countries must be used.
• Because the LT-9001 Series is designed as class I equipment, be sure to
connect the protective earthing terminal located in the inlet to the protective
earthing conductor in the building when installing it.
• When replacing the fuse, be sure to use the fuse that satisfies the following
rating and is approved by certification organization based on the appropriate
EU standard.
Fuse rating 250 V, 3.15 A, Time lag fuse
Precautions
E LT-9001-IM
LT-9000-M-NO0-E.qxd 09.10.15 9:40 PM ページ4