KEYENCE LT-9001 Series - Manual (Page 68)

Operations
and
Fun
ction
Settings
in
the
Profile
Mode
4
Chapter
E LT-9001-IM
4-2
Types of Screens
Six types of screens are displayed in the profile mode as shown below.
Program mode
Run mode
switch switch
• Program change screen
You can register a set of parameter settings to
perform measurement as a program. The registered
program number can be changed on this screen.
• Program mode screen
Makes the respective settings for measurement,
such as the measurement selection.
• Environment setting screen
Makes the basic settings for operating the LT-9001,
such as the communication parameters.
• Measurement screen
Displays the measured profile as a value according
to the settings. The point data (the data measured
for the respective points) within the scanning width
is also displayed as a profile waveform graph.
• Light intensity screen
Displays the measured value and how the light
intensity of the point data is distributed within the
scanning width in a bar graph.
• Pause screen
Stops the update of a profile waveform graph and
measures the displacement at any position.