KEYENCE LT-9001 Series - Manual (Page 23)

2
Chapter
Basic
Operations
E LT-9001-IM
2-5
Four types of settings (OUTPUT settings, BASIC settings, OPTIONAL settings, and Environment settings) can
be performed in the program mode according to the target to measure.
OUTPUT settings
Performs settings for OUT1 and OUT2 respectively.
Program Mode
Sets the upper and lower limits of the tolerance.
Sets the measurement method and the processing of the measured data.
MEASURMENT
SELECT SURFACE
AVERAGE
HOLD MODE
OFFSET
ANALOG output
UPPER LIMIT
LOWER LIMIT
Measured value
and
calibrated value
Calibrates the error caused by slant or refractive.
Displacement mode Profile mode Setting item
Displacement mode Profile mode Setting item
Displacement mode Profile mode Setting item
Chapter 5 "OUT Settings" - "LIMITS" (page 5-7)
Chapter 5 "OUT Settings" - "ANALOG output" (page 5-15)
Chapter 5 "OUT Settings" - "OFFSET" (page 5-14)
Chapter 5 "OUT Settings" - "HOLD MODE" (page 5-9)
Chapter 5 "OUT Settings" - "AVERAGE" (page 5-8)
Chapter 3 "OUT Settings" -
"Measurement" (page 3-10) Chapter 4 "OUT Settings" -
"Measurement" (page 4-12)
Chapter 3 "OUT Settings" -
"SELECT SURFACE" (page 3-12)
Chapter 5 "OUTPUT Settings" - "CALIB" (page 5-16)
LIMITS (Tolerance)
CALIB (Calibration)
OUTPUT