Lull 6K Service Manual User Manual
Page 624
Outriggers
10-6
Service Manual — Models 644B, 6K, 844C, 8K, 1044C, 10K
Removal
Outrigger Cylinders
Fig. 10-4: Outrigger Cylinder Installation
(Ref. Fig. 10-4) The following procedure describes removal of the outrigger
cylinders.
1. Follow preparation procedures as outlined in Section 3 of this manual.
2. Lower the boom, apply the parking brake, raise the outrigger foot pads
completely, and shut the engine off.
3. Disconnect the wiring harness (Item 1) from the differential pressure
switch (Item 3) on both cylinders. Remove the ties (Item 2) securing
the pressure switch wires to the wiring harness or the hydraulic hoses.
4. Loosen two (2) hydraulic hoses (Item 6) from the elbows (Item 5) on
both outrigger cylinders (Item 4).
CAUTION: Use suitable blocking and lifting devices when removing the
cylinders. Care must be taken when removing and lifting the
cylinders to prevent personal injury or equipment damage.
V
1084
#
Description
1
Wiring Harness
2
Tie
3
Differential Pressure Switch
4
Outrigger Cylinder
5
Elbow
6
Hydraulic Hose
7
Pin
#
Description
8
Capscrew
9
Lockwasher
10 Lock Pin
11 Pin
12 Capscrew
13 Lockwasher
14 Lock Pin
1
2 3
4
5
6
7
8
9
10
11
12
13
14