Lull 6K Service Manual - Manual (Page 317)

Boom and Transfer
Service Manual — Models 644B, 6K, 844C, 8K, 1044C, 10K 6-67
11. (Ref. Fig. 6-64) Position inner boom section to obtain the indicated
dimensions.
Fig. 6-65: Gaps Between Pads and Boom – Front of 2-Section Boom
12. (Ref. Fig. 6-65) Install/remove shim(s) under indicated pads to obtain
specified clearances.
13. Extend boom and lubricate per previous instructions.
14. Check boom extension and retraction for binding against slide pads.
Inspection Procedures
2-Section Boom These procedures are intended to determine if localized deformation has
occurred on the inner boom section.
1. Extend the boom and lower the forks to the ground.
Front of Boom, Looking Rearward J1054
0.030"–0.063"
(1/32"–1/16") gap
between pads and
boom