Lull 6K Service Manual - Manual (Page 468)

Boom and Transfer
6-218 Service Manual — Models 644B, 6K, 844C, 8K, 1044C, 10K
The transfer carriage, along with the transfer cylinder, make up the “Trans-
Action” feature. This feature makes it possible to land materials from a
parked, level machine by driving the boom load forward at any height. The
operator can then retract the boom and forks by moving the entire upper
assembly rearward without driving the machine on uneven terrain.
Removal
Transfer Carriage The following steps are required to remove the transfer carriage.
1. Follow preparation procedures as outlined in Section 3 of this manual.
2. Lower the boom to the ground, apply the park brake, retract the
transfer cylinder, and stop the engine.
Fig. 6-232: Disconnecting Transfer Cylinder from Transfer Carriage
3. (Ref. Fig. 6-232) Loosen two (2) socket setscrews in rod nut securing
transfer cylinder to the transfer carriage.
4. (Ref. Fig. 6-232) Remove transfer cylinder rod nut and washer.
5. Move transfer carriage forward enough so that the threaded port of
transfer cylinder rod comes clear from its mounting hole. Block and
secure the transfer cylinder to the main frame.
J
113
9
Setscrew
Washer
Rod Nut