Lull 6K Service Manual - Manual (Page 421)

Boom and Transfer
Service Manual — Models 644B, 6K, 844C, 8K, 1044C, 10K 6-171
16. (Ref. Fig. 6-185) Disconnect chains from rear of middle (forward) boom
as follows:
a. Remove two (2) lock nuts (Item 2), chain anchor rod (Item 6), and
upper chain (Item 1).
b. Remove capscrew (Item 4), lockwasher (Item 5), and upper chain
anchor (Item 3).
c. Remove capscrew (Item 14), lockwasher (Item 15), and hose reel
pin (Item 16) securing each of the two (2) hose reels (Item 13) to
the rear of the middle (forward) boom section. Remove hose reels.
d. Remove two (2) each capscrews (Item 7) and lockwashers (Item 8)
securing lower chain anchor (Item 12) to middle (forward) boom
section.
e. Remove lock nut (Item 9), shoulder bolt (Item 11), and lower chain
anchor from lower chain (Item 10).
17. (Ref. Fig. 6-184) Pull upper chain (Item 2) out through front of boom.
18. Slide inner and middle (forward) boom sections out of middle (rear)
boom section. Place middle (forward) section (with inner) on work
stands upside down.
Fig. 6-186: Slide Pad Removal – Inner Boom Section
19. (Ref. Fig. 6-186) Remove eight (8) capscrews (Items 1 and 3) and
lockwashers (Items 2 and 4) securing two (2) side and two (2) bottom
slide pads (Items 5 and 6) to rear of inner boom section. Remove slide
pads.
J
1236
4
3
1
2
5
6
# Description
1 Button-Head Socket Capscrew
2 Lockwasher
3 Button-Head Socket Capscrew
# Description
4 Lockwasher
5 Side Slide Pad
6 Bottom Slide Pad