beautypg.com

Suppress zoning rscns on zone set activations, Configuring fabric parameters, Fabric parameters – HP StorageWorks 2.32 Edge Switch User Manual

Page 82

background image

Configuring the switch

82

Suppress zoning RSCNs on zone set activations

Fabric format domain RSCNs are sent to ports on the switch following any change to the fabric's

active zone set. These changes include activating and deactivating the zone set, or enabling and

disabling the default zone. When the Suppress RSCNs on Zone Set Activations check box contains

a check, fabric format RSCNs are not sent for zone changes to the attached devices on the switch.

Click the check box to remove or add a check.
In general, RSCNs should not be suppressed, so that attached devices can receive notification of

zoning changes in the fabric. However, some HBAs may log out, then log back into the fabric when

they receive an RSCN, thereby disrupting Fibre Channel traffic. Consult with your HBA and storage

device vendor to determine if zone set change RSCNs will cause problems with your HBA or storage

products.

Configuring fabric parameters

The Configure Fabric Parameters dialog box enables you to configure the Fibre Channel operating

parameters.

Fabric Parameters

To set fabric parameters:

NOTE:

The switch must be off line to change parameters in this dialog box. If it is not and you

activate values in this dialog box, a dialog box is displayed, prompting you to set the unit off line.

CAUTION:

Setting the switch off line terminates all Fibre Channel connections.

1.

Set the unit off line:
a. Select Maintenance > Set Online State. The Set Online State dialog box is displayed.
b. Click Set Offline. A warning box is displayed asking you to confirm the off line state.
c. Click OK.

This manual is related to the following products: