HP StorageWorks 2.32 Edge Switch - Manual (Page 101)

Edge Switch Element Manager user guide 101
Or
Click No and return to the Devices tab where you can add the devices to the Authenticated
Devices list.
Changing port authentication state for a nonmember device (manageable) without CHAP
Secret
If the port authentication state is changed to Forced Enabled or Switch Setting from the
corresponding authentication state while the E_port authentication is checked, the Secret column
changes its display value from
No
to
Needed
.
1. Double click the corresponding Secret column or select the device and click the right arrow
button to display the Add User dialog box.
2. Select the CHAP secret, and then click OK.
The corresponding Secret column displays
Set
. The device is added to the Authenticated
Devices list. The secret is populated to both the device’s local database and the current switch’s
Authenticatable list.
Changing the port authentication state for a nonmember device that is not managed
1. Select the E_port authentication check box for a device that is not manageable.
2. Change the port authentication state to Force Enabled or Switch Settings.
The Secret column changes from
No
to
Needed
.
3. Double-click the corresponding Secret column to display the Add User dialog box.
4. Type the CHAP secret.
5. Click OK.
The Secret column for that device displays
Set
. The device is added to the Authenticated
Devices list. The secret is populated to the current switch’s Authenticated Devices list.
6. Access the device that is not managed and populate the same Secret into the local database.
Applying changes and confirmation
1. Click Apply from the Devices tab.
The Security Change Confirmation and Status dialog box is displayed.
This dialog box is similar in behavior to the Security Change Confirmation and Status that is
displayed from the Users tab. The only difference is in the Detailed Changes table. On the
Devices tab there is no Apply To available, so there is always one product in the product list. This
table displays the difference between the current settings of the Devices tab and to-be-populated
new settings.
2. Click Apply even if there are no security settings being changed.
If there are no security settings being changed, the Security Change Confirmation and Status
dialog box is displayed with the Detailed Changes table showing that
No Changes were
Found
on the first row.
3. Click Start and the status window displays a message indicating the security settings are
identical and there are no changes to apply.