HP StorageWorks 2.32 Edge Switch - Manual (Page 206)

Information and error messages 206
Cannot start data
collection.
The data collection procedure
cannot be started by the Element
Manager because the Ethernet
link is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot start firmware
install while CTP
synchronization is in
progress.
The director’s CTP cards are
synchronizing and firmware
cannot be installed until
synchronization is complete.
Install the firmware after CTP card
synchronization completes.
Cannot start port
diagnostics.
Port diagnostics cannot be started
at the Element Manager because
the Ethernet link is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot swap an
uninstalled port.
A port swap cannot be performed
when the port card is not installed.
Perform a swap only on a port that is
installed.
Click OK to remove all
contents from log.
This action deletes all contents
from the selected log.
Click OK to delete the log contents or
click Cancel to cancel the operation.
Connection to
management server
lost. Click OK to exit
application.
The HAFM application at a remote
workstation lost the network
connection to the HAFM
appliance.
Start the HAFM application to connect
to the HAFM appliance.
Continuing may
overwrite host
programming. Continue?
Configurations sent from the host
may be overwritten by HAFM.
Continuing will activate the current
configuration, which may have been
configured by a FICON host.
Could not export log
to file.
A log file I/O error occurred and
the file could not be saved to the
specified destination. The disk
may be full or write protected.
Ensure file name and drive are correct.
Could not find
firmware file.
Firmware file selected was not
found in the FTP directory. Or, the
selected file is not a firmware file.
Ensure file name and directory are
correct. Or, obtain a valid firmware file
from your service representative.
Could not remove dump
files from server.
Dump files could not be deleted
from the HAFM appliance
because the link may be down, or
the HAFM appliance or Element
Manager is busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Table 10 Element Manager messages (continued)
Message Description Action