Setting date and time manually – HP StorageWorks 2.32 Edge Switch User Manual
Page 125
Edge Switch Element Manager user guide 125
2.
You can set the switch date and time manually or you can set it for periodic synchronization with
the HAFM appliance. For specific instructions, see the following sections:
•
Setting date and time manually
•
Setting date and time manually
Use these steps to set the switch date and time manually:
1.
At the Configure Date and Time dialog box, click the Periodic Date/Time
Synchronization check box to deselect the option (no check mark in the box). The grayed-out
Date and Time fields are activated, as shown in
.
Figure 49
Configure Date and Time dialog box (manual options)
2.
Click the Date fields that require change, and type numbers in the following ranges:
Month (MM): 1 through 12
Day (DD): 1 through 31
Year (YYYY): greater than 1980
3.
Click the Time fields that require change, and type numbers in the following ranges:
Hour (HH): 0 through 23
Minute (MM): 0 through 59
Second (SS): 0 through 59
4.
Click Activate to set the director date and time and close the Configure Date and Time dialog
box.