Modifying alerts, Activating or deactivating alerts, Viewing alerts – HP StorageWorks 2.32 Edge Switch User Manual
Page 131

Edge Switch Element Manager user guide 131
Modifying alerts
To modify an existing threshold alert configuration:
1.
Select Configure > Threshold Alerts. The Configure Threshold Alerts dialog box is
displayed as shown in
2.
Select the alert that you want to modify by clicking the alert information in the table.
3.
If the alert is active, click Deactivate, then choose the alert information in the table again.
4.
Click Modify to change the threshold type in the Modify Threshold screen as shown in
5.
Select a threshold type from the list.
6.
Click Next to display the next Modify Threshold screen as shown in
Change the % utilization in the Modify Threshold screen. The % utilization is the cumulative
minutes for the threshold to occur before notification, and the time interval for measuring
throughput and for alert notification.
7.
Make appropriate changes, then continue through the Modify Threshold screens, making
changes as necessary, until the summary screen displays the alert configuration.
8.
If you need to change any parameters, click Previous and Next to display the desired Modify
Threshold screen.
9.
Click Finish when you are done.
If you want to view the details of the modified threshold alert, follow the procedures in ”
Activating or deactivating alerts
Use the following steps to activate or deactivate existing threshold alerts. In the active state,
notifications are generated for the alert. In the inactive state, notifications do not occur.
1.
Select Configure > Threshold Alerts from the menu.
The Configure Threshold Alerts dialog box is displayed as shown in
The port’s current state,
Inactive
or
Active
, is listed in the State column.
2.
Select the alert you want to change.
3.
If the alert is active, click Deactivate to change to the inactive state. If the alert is inactive, click
Activate to change to the active state.
Viewing alerts
Use the following steps to view existing threshold alerts.
1.
Select Configure > Threshold Alerts. The Configure Threshold Alerts dialog box is
displayed.
2.
Select the alert that you want to view by selecting the alert information in the table.
3.
Click View. The View Threshold Alerts dialog box is displayed, describing the threshold alert
and the ports to which the alert has been applied.