HP StorageWorks 2.32 Edge Switch - Manual (Page 210)

Information and error messages 210
Feature not supported.
The ‘product name’
must be running
version 05.00.00 or
higher.
The firmware version on the
hardware product (switch or
director) is lower than 05.00.00.
This message is displayed only if
the optional Open Trunking
feature is installed.
Install firmware version 5.00.00 or
higher on the hardware product.
Field cannot be blank.
The data field requires an entry
and cannot be left blank.
Enter appropriate information in the
Data field.
Field has exceeded
maximum number of
characters.
The maximum number of data
entry characters allowed in the
field was exceeded.
Enter the information using the
prescribed number of characters.
File transfer aborted.
You aborted the file transfer
process.
Informational message only—no
action is required
File transfer is in
progress.
A firmware file is being transferred
from the HAFM appliance hard
drive, or a data collection file is
being transferred to a CD.
Informational message only—no
action is required.
Firmware download
timed out.
The director or switch did not
respond in the time allowed. The
status of the firmware install
operation is unknown.
Retry the operation. If the problem
persists, contact the next level of
support.
Firmware file I/O
error.
A firmware download operation
aborted because a file I/O error
occurred.
Retry the operation. If the problem
persists, contact the next level of
support.
Firmware file not
found.
The firmware version is not
installed (or was deleted) from the
firmware library at the HAFM
appliance.
Add the firmware version to the library
and retry the operation.
Incompatible
configuration between
management style and
management server.
If the Firmware is below the
required level and the FICON
Management Server feature is
enabled, only FICON
management style is allowed.
Disable the FICON Management
Server, enable the Open Systems
Management Server, or enable the
Open Systems management style.
Incorrect product
type.
When configuring a new product
through the New Product dialog
box, an incorrect product was
specified.
Select the correct product type for the
product with the network address.
Table 10 Element Manager messages (continued)
Message Description Action