HP StorageWorks 2.32 Edge Switch - Manual (Page 102)

Configuring the switch 102
Using the IP Access Control List tab
The switch IP ACL tab ( Figure 32 ) contains IP addresses for devices that are allowed to manage the
switch. IP addresses that are not on this list cannot manage the switch from the IP management port.
Figure 32 Configure Security Authentication IP Access Control tab
If the Enable IP Access Control List check box is selected, the restricted access to the follow IP
addresses is enforced. If not checked, management interfaces can access the switch from any IP
address. The check box is enabled only if at least one IP address is in the list.
Adding a new IP address
1. Click Add.
The Add/Edit IP Address or Range dialog box is displayed.
2. Enter an IP Address or an IP Address Range.
The IP range is defined by a starting IP address and ending IP address.
3. Click Apply.
Editing one IP address or one range of IP addresses
1. Click Change.
The Add/Edit IP Address or Range dialog box is displayed.
2. Change the IP address or IP Address Range.
3. Click Apply.
NOTE: If multiple IP address or ranges are selected, Edit is disabled.