HP StorageWorks 2.32 Edge Switch User Manual
Page 29
Edge Switch Element Manager user guide
29
NOTE:
Ports are automatically configured as G_Ports if no device is connected, F_Ports if a
device is connected, E_Ports if a switch is connected, and FL_Port if connected to a loop
device.
•
Allow/Prohibit Matrix (FICON Management only)—Edge Switch 2/32 only. Select one of the
following options:
• Active Addresses—Displays the Configure-Addresses—“Active” dialog box. Use this dialog
box to configure a name, blocked or unblocked state, and prohibited and allowed
connection attributes for a port.
• Stored Addresses—Displays the Address Configuration Library. Use this dialog box to
activate, modify, delete, and modify existing address configurations created through the
Active Addresses dialog box.
•
SNMP agent—Displays the Configure SNMP dialog box. Use this dialog box to configure
network addresses and community names for up to six SNMP trap recipients. You can also
authorize write permissions to enable SNMP management stations to modify writable
Management Information Base (MIB) variables. In addition, you can enable authorization traps
to be sent to management stations when unauthorized stations request access to switch SNMP
data.
•
FICON Management Server—Edge Switch 2/32 only. This option only is displayed if the FICON
Management Server in-band management feature was enabled through the Configure Feature
Key dialog box. (See ”
Configuring the feature key” on page 122
for more information.) You can
select the following suboptions:
• Enable FMS—Displays a check mark and enables the FICON Management Server.
• Parameters—Displays the Configure FICON Management Server dialog box. Use this
dialog box to perform the following tasks:
• Allow or prohibit director clock alert mode.
• Allow or prohibit programmed off line state control.
• Select a code page from the Code Page list.
For details, see ”
•
Open Systems Management Server—Displays the Configure Open Systems Management Server
dialog box. This dialog box will only display if the Open Systems Management Server feature is
enabled for the switch. (This feature allows you to manage switches without using the HAFM
application.) Use this menu option to configure an open systems in-band management program
to function with the switch.
NOTE:
To use the Management Server options, you must have enabled the Open Systems
Management Server through the Configure Feature Key dialog box. See
for more information.