HP StorageWorks 2.32 Edge Switch - Manual (Page 200)

Information and error messages 200
Element Manager messages
Table 10 lists Element Manager information and error messages in alphabetical order
Table 10 Element Manager messages
Message Description Action
A Preferred Path
already exists between
this Source Port and
this Destination
Domain ID. Please
re-configure the
desired path.
For any source port, only one path
may be defined to each
destination domain ID.
On the Add/Change Preferred Path
dialog box, change the preferred path.
Activating this
configuration will
overwrite the current
configuration.
Confirmation to activate a new
address configuration.
Click Yes to confirm activating the new
address configuration or No to cancel
the operation.
All configuration
names must be unique.
All address configurations must be
saved with unique names.
Save the configuration with a name
that is unique to all saved
configurations.
All FPM ports will be
held inactive while
the director is
configured to 2 Gb/sec
speed. Do you want to
continue?
Occurs when FPM cards are
installed in the director and
director speed is being set to
2 Gb/sec in the Configure Switch
Parameters dialog box.
Replace FPM cards with UPM cards
(UPM cards operate at 1 and 2
Gb/sec) or set the director speed to
1 Gb/sec.
All port names must be
unique.
A duplicate Fibre Channel port
name was configured. All port
names must be unique.
Reconfigure the Fibre Channel port
with a unique name.
All port names must be
unique.
A duplicate port name was
entered. Every configured port
name must be unique.
Reconfigure the port with a unique
name.
An Element Manager
instance is already
open.
Only one instance of the Element
Manager can be open at one
time.
Close the open Element Manager so
the desired instance of the Element
Manager can be opened.
Another Element
Manager is currently
performing a firmware
install.
Only one instance of the Element
Manager can install a firmware
version to the director at a time.
Wait for the firmware installation
process to complete and try the
operation again.