HP StorageWorks 2.32 Edge Switch - Manual (Page 205)

Edge Switch Element Manager user guide 205
Cannot save SNMP
configuration.
The SNMP configuration cannot
be saved at the Element Manager
because the Ethernet link is down
or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot set all ports
to 1 Gb/sec due to
speed restriction on
some ports.
You tried to set ports to operate at
1 Gb/sec data speed through the
Configure Ports dialog box and
some ports do not support speed
configuration.
Replace ports that do not support
speed configuration with those that do
support more than one configuration.
Cannot set all ports
to 2 Gb/sec due to
speed restriction on
some ports.
You tried to set ports to operate at
2 Gb/sec data speed through the
Configure Ports dialog box and
some ports do not support speed
configuration.
Replace ports that do not support
speed configuration with those that do
support more than one configuration.
Cannot set all ports
to Negotiate due to
port speed restriction
on some ports.
You tried to set all ports to
Negotiate through the Configure
Ports dialog box and some ports
do not support speed
configuration.
Replace ports that do not support
speed configuration with those that do
support more than one speed
configuration.
Cannot set Fibre
Channel parameters.
Fibre Channel parameters for the
director cannot be set at the
Element Manager because the
Ethernet link is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot set switch date
and time.
The switch date and time cannot
be set at the Element Manager
because the Ethernet link is down
or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot set switch
state.
The director or switch state cannot
be set at the Element Manager
because the Ethernet link is down
or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot set write
authorization without
defining a community
name.
A community name was not
defined in the Configure SNMP
dialog box for the write
authorization selected.
Provide a name in the Name field
where write authorization is checked.
Table 10 Element Manager messages (continued)
Message Description Action