beautypg.com

Figure 75 configure preferred paths dialog box, 75 configure preferred paths dialog box – HP StorageWorks 2.32 Edge Switch User Manual

Page 165

background image

Edge Switch Element Manager user guide 165

To add a new preferred path:

TIP:

You may need to configure preferred paths on multiple switches or directors to optimize load

balancing for an entire path between devices.

1.

Select Configure > Preferred Path.

The Configure Preferred Paths dialog box is displayed as shown in

Figure 66

.

Figure 75

Configure Preferred Paths dialog box

The Configure Preferred Paths dialog box provides the configuration for a single switch’s

preferred path.

NOTE:

Some columns are displayed only when the FICON Management Style feature has

been installed.

2.

Take the appropriate action:
• If a warning message is displayed notifying you that the switch or director has not been

configured for insistent domain ID:
• Close the dialog box and select Configure > Operating Parameters > Switch Parameters.
• Select the Insistent check box in the Configure Switch Parameters dialog box.
• Return to the Configure Preferred Paths dialog box and continue to

step 3

.

• If there is no warning message, continue with

step 3

.

3.

Click Add to configure a new preferred path.

The Add Preferred Path dialog box is displayed as shown in

Figure 67

.

Figure 67

Add Preferred Path dialog box

4.

Click the lists for the Source Port, Exit Port, and Destination Domain ID to make your selections.

See

Exporting the Configuration Report

” on page 132 for more information.

This manual is related to the following products: