HP StorageWorks 2.32 Edge Switch - Manual (Page 212)

Information and error messages 212
Invalid port address.
Invalid port address has been
entered.
Verify that the port address through
the Configure Addresses–“Active”
dialog box (FICON management style
only) and re-enter.
Invalid port number.
The port number must be within a
range of ports for the specific
director or switch model.
Enter a port number within the correct
range.
Invalid port swap.
Port swap selection is not allowed. Ensure that each port selected for
swap has not been previously
swapped.
Invalid response
received from switch.
An error occurred at the switch
during a firmware download
operation.
Retry the firmware download
operation. If the problem persists,
contact the next level of support.
Invalid response
received from
director.
An error occurred at the director
during a firmware download
operation.
Retry the firmware download
operation. If the problem persists,
contact the next level of support.
Invalid serial number
for this feature key.
The serial number and the feature
key did not match.
Ensure that the feature key being
installed is specifically for this director
serial number.
Invalid UDP port
number.
The specified user datagram
protocol (UDP) port number is
invalid. The number must be an
integer from 1 through 65535
inclusive.
Verify and enter a valid UDP port
number from 1 through 65535.
Invalid value for
BB_Credit.
At the Configure Fabric
Parameters dialog box, the
buffer-to-buffer credit (BB_Credit)
value must be an integer from 1
through 60 inclusive.
Verify and enter a valid number
between 1 through 60.
Invalid value for Low
BB Credit threshold
(1-99) %.
Low BB Credit Threshold field in
Configure Open Trunking dialog
box must have entries in the range
from 1 and 99. This message is
displayed only if the optional
Open Trunking feature is installed.
Enter a value from 1 to 99 into the Low
BB Credit Threshold field of the
Configure Open Trunking dialog box.
Table 10 Element Manager messages (continued)
Message Description Action