HP StorageWorks 2.32 Edge Switch - Manual (Page 194)

Information and error messages 194
Route request timeout.
The Show Route request timed
out.
Try the operation again. If the problem
persists, contact the next level of
support.
Routing is not
supported by the
switch.
This switch or director does not
support the Show Routes feature.
Select a different switch or director to
show the route.
SANtegrity Feature not
installed. Please
contact your sales
representative.
You selected Fabric Binding or
Enterprise Fabric Mode from the
Fabrics menu. These selections
are not enabled because the
optional SANtegrity binding
feature is not installed.
Install the SANtegrity Binding feature
to use Fabric Binding or enable
Enterprise Fabric Mode.
Select alias to add to
zone.
An alias was not selected before
clicking Add.
Select an alias before clicking Add.
Selection is not a
World Wide Name.
The selection made is not a
WWN.
Select a valid WWN before
performing this operation.
Server shutting down.
The HAFM application is closing
and terminating communication
with the attached product.
Reboot the HAFM appliance. If the
problem persists, contact the next level
of support.
SNMP trap address not
defined.
If an SNMP community name is
defined, a corresponding SNMP
trap recipient address must also
be defined.
Enter a corresponding SNMP trap
recipient address.
Switch is not managed
by HAFM.
The selected switch or director is
not managed by the HAFM
application.
Select a different switch or director.
The Administrator user
cannot be deleted.
The administrator user is
permanent and cannot be deleted
from the Configure Users dialog
box.
Informational message only—E_port is
required.
The Domain ID was not
accepted. The World
Wide Name and Domain
ID must be unique in
the Fabric Membership
List.
You attempted to add a detached
switch to the Fabric Membership
List through the Fabric Binding
option (SANtegrity Binding
feature), but a switch already
exists in the fabric with the same
domain ID.
Enter a unique domain ID for the switch
in the Add Detached Switch dialog
box.
Table 9 HAFM messages (continued)
Message Description Action