HP StorageWorks 2.32 Edge Switch - Manual (Page 220)

Information and error messages 220
This feature is not
installed. Please
contact your sales
representative.
This feature has not been installed. Contact your sales representative.
This feature key does
not include all of the
features currently
installed and cannot
be activated while the
switch is online.
The feature set currently installed
for this system contains features
that are not being installed with
the new feature key. To activate the
new feature key, you must set the
switch off line. Activating the new
feature set, however, will remove
current features that are not in the
new feature set.
Set the switch off line through the Set
Online State dialog box, then activate
the new feature key using the
Configure Feature Key dialog box.
The new feature key will display both
the new features and the features that
were installed previously.
This feature key does
not include all of the
features currently
installed. Do you want
to continue with
feature key
activation?
The feature set currently installed
for this system contains features
that are not being installed with
the new feature key.
Click Yes to activate the feature key
and remove current features not in the
new feature set or No to cancel.
Threshold alerts are
not supported on
firmware earlier than
01.03.00.
Threshold alerts are not supported
on firmware earlier than 01.03.00.
Informational message only—no
action is required.
Unable to change
incompatible firmware
release.
You tried to download a firmware
release that is not compatible with
the current product configuration.
Refer to the product release notes or
contact the next level of support to
report the problem.
Unable to save data
collection file to
destination.
The HAFM appliance could not
save the data collection file to the
specified location (PC hard drive,
CD, or network).
Retry the operation. If the condition
persists, contact the next level of
support.
You do not have rights
to perform this
action.
Configured user rights do not
allow this operation to be
performed.
Verify user rights with the customer’s
network administrator and change as
required.
Table 10 Element Manager messages (continued)
Message Description Action