beautypg.com

HP StorageWorks 2.32 Edge Switch User Manual

Page 207

background image

Edge Switch Element Manager user guide 207

Could not stop port

diagnostics.

Port diagnostics could not be

stopped by the Element Manager

because the Ethernet link is down

or busy, or because the director is

busy.

Retry the operation later. If the

condition persists, contact the next

level of support.

Could not write

firmware to flash.

A firmware version could not be

written from the HAFM appliance

to FLASH memory

Retry the operation again. If the

condition persists, contact the next

level of support.

Control Unit Port

(CUP) name and port

name are identical

(FICON ONLY).

Within the address configuration,

one or more of the port names are

the same as the CUP name.

Make sure all names are unique for

the ports and CUP name.

Date entered is

invalid.

The date is entered incorrectly at

the Configure Date and Time

dialog box. Individual field entries

may be correct, but the overall

date is invalid (for example, a day

entry of 31 for a 30-day month).

Verify that each entry is valid and

consistent.

Device applications

should be terminated

before starting

diagnostics. Press

NEXT

to continue.

Port diagnostics (loopback tests)

cannot be performed on a port

while an attached device

application is running.

Terminate the device application and

perform diagnostics again.

[device WWN] cannot be

removed from the

Switch Membership List

while participating in

Switch Binding. The

device must be

isolated from the

switch, or Switch

Binding deactivated

before it can be

removed.

You attempted to remove a device

WWN from the Switch

Membership List (SANtegrity

Binding feature) while Switch

Binding is enabled.

Remove the device from the switch by

blocking the port, setting the switch off

line, or disabling Switch Binding

through the Switch Binding Change

State dialog box before removing

devices from the Switch Membership

List.

Table 10

Element Manager messages (continued)

Message

Description

Action

This manual is related to the following products: