HP StorageWorks 2.32 Edge Switch - Manual (Page 219)

Edge Switch Element Manager user guide 219
The link to the switch
is not available.
The Ethernet connection between
the HAFM appliance and the
switch is down or unavailable.
Establish and verify the network
connection.
The IPL configuration
cannot be deleted.
Deletion of the IPL address
configuration was attempted and
was not allowed.
Cancel the operation.
The management server
is busy processing a
request from another
Element Manager.
The HAFM appliance is
processing a request from another
instance of an Element Manager,
and cannot perform the requested
operation.
Wait until the process is completes,
then perform the operation again.
The optical
transceiver is not
installed.
Information is not available for a
port without an optical transceiver
installed.
Install an SFP optical transceiver in the
port.
The switch did not
accept the request.
The director or switch cannot
perform the requested action.
Retry the operation. If the condition
persists, contact the next level of
support.
The maximum number of
address configurations
has been reached.
The maximum number of saved
address configurations has been
reached.
Delete configurations no longer
needed to allow new configuration to
be saved.
The switch did not
respond in the time
allowed.
While waiting to perform a
requested action, the director or
switch timed out.
Retry the operation. If the condition
persists, contact the next level of
support.
The switch is busy
saving maintenance
information.
The director or switch cannot
perform the requested action
because it is busy saving
maintenance information.
Retry the operation later. If the
condition persists, contact the next
level of support.
The switch must be
offline to change the
Management Style.
You attempted to change the
management style.
Select Set Online State from the
Maintenance menu and click Set
Offline. Then change the management
style. Set the director or switch back on
line when finished.
The switch must be
offline to configure.
A configuration change was
attempted for a configuration
requiring off line changes.
Take the appropriate actions to set the
director or switch off line before
attempting the configuration change.
Table 10 Element Manager messages (continued)
Message Description Action