IAI America MSCON - Manual (Page 45)

Chapter 1 Specifications Check
37
(4) Heat Radiation and Installation
Design and Build the system considering the size of the controller box, location of the controller
and cooling factors to keep the ambient temperature around the controller below 40qC
Pay a special attention to the battery unit since the performance of it would drop both in the low
and high temperatures. Keep it in a room temperature environment as much as possible.
(Approximately 20qC is the recommended temperature.)
To install the unit, use the attachment holes on the top and bottom of the main body and affix
with screws, or attach to DIN rails. (Regenerative resistance unit is separated to screw
attachment type and DIN rail attachment type. Have an appropriate way to affix the unit for
each type.)
20mm or more
50mm or more
20mm
or more
20mm or more
30mm
or more
20mm or more
10mm or more
10mm
or more
50mm or more
150mm or more
Waste
Heat