IAI America MSCON - Manual (Page 229)

3.9
About Gateway Parameter Setting
Tool
221
3) GW mode Select
x Enable SW : Select whether to activate/inactivate the enable switch in
TP.
x BYTE swap : Set the byte swap. [Refer to 3)-1 in this section.]
x WORD swap in D-WORD Data : Set whether to swap the W-word sized data with word size.
[Refer to 3)-2 in this section.]
x Enable SW in AUTO mode : Select whether to activate/inactivate the enable switch in
AUTO mode.
3)-1 BYTE swap: Swap the upper and lower in the sent and received data in byte unit. Set
this considering the connected host system if necessary.
Ɣ = ON, ż = OFF
MSEP
ON/OFF
ON/OFF
ON/OFF
ON/OFF
౉ജ
࡟ࠫࠬ࠲
16ㅴ
࠺࡯࠲
16ㅴ
࠺࡯࠲
16ㅴ
࠺࡯࠲
16ㅴ
࠺࡯࠲
MSEP
RWwnn
PLC ：
RWrnn
಴ജ
࡟ࠫࠬ࠲
MSCON
Input
register
MSCON
Output
register
Hexadecimal
data
Hexadecimal
data
Hexadecimal
data
Hexadecimal
data