IAI America MSCON - Manual (Page 286)

Chapter 7 Parameter
278
[85] Total movement count threshold (Parameter No.147)
No. Name Symbol Unit Input Range
Default factory
setting
147 Total Movement Count Threshold TMCT Times 0 to 999999999 0 (Disabled)
An alarm is generated when the total movement count exceeds the value set to this parameter.
The judgment would not be made if the value is set to 0.
[86] Total operated distance threshold (Parameter No.148)
No. Name Symbol Unit Input Range
Default factory
setting
148 Total Operated Distance
Threshold
ODOT m 0 to 999999999 0 (Disabled)
An alarm is generated when the total operation distance exceeds the value set to this
parameter.
The judgment would not be made if the value is set to 0.
[87] Zone output changeover (Parameter No.149)
No. Name Symbol Unit Input Range
Default factory
setting
149 Zone Output Changeover FPIO -
0: Not to change
1: To change
0
In Remote I/O Mode, the effective zone signals are determined by the setting of this parameter
and the setting of Parameter No.25 PIO Pattern Select.
The relationship between the parameter settings and effective zone signal outputs are as
shown in the table below.
Parameter No.149
Zone Output Changeover
Operation
Mode
Parameter No.25
PIO pattern selection
0 1
0
ZONE1
PZONE
ZONE1
ZONE2
1
2
PZONE ZONE1
4
Remote I/O
Mode
5
ZONE1
PZONE
ZONE1
ZONE2
[88] Linear absolute home preset value (Parameter No.150)
This is the parameter for the future extension. Do not attempt to change the initial settings.
[89] Light error alarm output select (Parameter No.151)
No. Name Symbol Unit Input Range
Default factory
setting
151 Light Error Alarm Output Select FSTP -
0: Battery voltage
drop warning
output
1: Output of battery
voltage drop
warning or
message-level
alarm
0
It can be selected if an output is to be made when a message-level alarm is generated as well
as when the battery voltage drop error is occurred for the output condition of BALM signal.